DiyMobileAudio.com Car Stereo Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Hello people, i'm trying to decide on which oem integration processor to use in my install. Here's what i tentatively plan on using in my 2012 Toyota Tacoma Crew Cab:

OEM Toyota CD headunit
Arc KS 300.4 amp (to run front comps. and single 10" sub)
or
Alpine PDX-F6 amp
Zapco Reference 6.5 components (in front only).
Arc arc series 10" sub in a small sealed enclosure.

NO REAR SPEAKERS.

Any and all recommendations and comments are most welcome!

Thanks
 

·
Registered
Joined
·
2,709 Posts
Going on your planned system, I would look at the H660. I used to have an H650 and was running a similar set up, OEM head unit, front components and 10" sub. The H650 did a great job for me, setting it up was a little tricky (really only because the manual stinks) but once it was set it sounded good, and I pretty much left it alone.

The only reason I sold it is because I plan to pick up an MS8, but, that is not due to any fault with the H650. I just want to utilize my center speaker location and try Logic 7 out.

No experience with the cleansweep.
 
1 - 2 of 2 Posts
Top