DiyMobileAudio.com Car Stereo Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
209 Posts
Discussion Starter · #1 ·
My goal is to run an active 4-way setup.

Seas 27TBFCG tweet
dayton rs125s mid
image dynamics cx62 midbass
Seas Lotus 12" Subs

All this run off of a Pioneer P9 combo, a tru 2.100, tru 4.65 with bb upgrade, tru hammer.

I have a Scion tc and I was planning to rebuild the door and run all three drivers on axis as much as possible and run the seas in the rear hatch area.

My main questions are:

A)Is there anything glaringly noticeable that would cause you to change this setup?

B) Would there be any good in mounting the tweet and mid in a pod on the a pillar and the midbass in the door?

C) Would a small sub custom built into the dash do anything for imaging?

Any and all advice/criticism would be greatly appreciated.

Thanks in advance.
 

·
Registered
Joined
·
209 Posts
Discussion Starter · #3 ·
Thanks npdang. The only reason I put the ID in there is because by spec it seems to give the most output. I just want a midbass that kicks so hard that it takes my breath away while still sounding clean. Any suggestions?
 

·
Registered
Joined
·
209 Posts
Discussion Starter · #5 ·
Thanks dodger. I don't plan to play these midbass speakers very high frequencies so really my focus is on midbass output and the ability to go low as possible.
 
1 - 3 of 3 Posts
Top