DIYMobileAudio.com Car Stereo Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
15 Posts
Discussion Starter · #1 ·
Hey guys I apologize in advance if this has been answered before, but I can not find the answer. I have a JBL GTO24001 amp and it has two sets of power inputs. My question(s) are i guess:

1) If i have 0 ga ran to the back do i just split it and run 4 ga to both inputs? The "owners guide" it came with only mentions connecting to the one set of inputs w/ the remote wire input.

2)Should i just run two ground wires from the amp to them same ground bolt on strut tower or ground them separately?

3)If i were to connect a battery in the trunk would i just hook the positive and ground from battery to the secondary inputs on amp, or do that but also ground the battery to the tower and run my 0 ga to the battery?

Thanks for any advice!
 

· Registered
Joined
·
785 Posts
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top