[DarkPowerXz]

Hello. I have some questions about using distribution block.
I have 2 amps. One for mids and one for bass.
I run a fused 1/0 awg gauge wire from battery to the trunk. I want to use distribution block 1/0 gauge wire input and x2 1/0 gauge wire output to every amp.
Is there going to be any problem with power decreasing or something like that?

 

[lithium]

No, just fuse the wire properly.

 

[GrM]

if your amps need/can fit 1/0 awg then that’s fine. But if you can get away with 4 or 8 awg between the block and amps that’d save you some money, unless you already have it.

KnuKonceptz - Home and Mobile audio accessories, including amp installation kits and speaker wire is a great place to get everything power/wire related, if they ship to your country, and the quality/price ratio is hard to beat or even match. But if you do get wires from them don’t get anything that’s not OFC unless you’re on a really tight budget.

 

[Selkec]

I use these on most my installs. It has two 1/0 inputs (that are joined) and two 1/0 and one 4/8ga outputs.

I like to use one 1/0 input coming from the front and the other I connect my rear battery or supercap bank

Bassik 3 Way 0 to 0 - 4 Gauge High Current Fuse Distribution Block - Merchandise

www.knukonceptz.com

 

[DarkPowerXz]

The amp for mids is Ampire mx4 and the one for the sub is Machete M2000D. Both will be using 1/0 gauge power/Ground wire.

 

[Forist]

Hello. I have some questions about using distribution block.
I have 2 amps. One for mids and one for bass.
I run a fused 1/0 awg gauge wire from battery to the trunk. I want to use distribution block 1/0 gauge wire input and x2 1/0 gauge wire output to every amp.
Is there going to be any problem with power decreasing or something like that?

I agree with Lithium.

 

[LBaudio]

no problem. I would also suggest, that you pull power wires for your HU/DSP from distro block too to prevent any possible issues with ground loop....