DiyMobileAudio.com Car Stereo Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1,249 Posts
Discussion Starter #1
Hey guys,after I finish the front pillars I'm going to start improving the low end as well.The original enclosure in the picture below has a separation wall as you can see.It is a sealed 1.9 cu.ft as is but my idea is to remove the center wall and use the upper well space.I'll fiberglass all of that in obviously.I figure that will get the enclosure to around 3-3.5 cu.ft..So if I wanted to port it what would be the best way to design the port? These are 2 Alpine type R's btw.




 

·
Registered
Joined
·
3,465 Posts
I don't know much about ports, but that box is looking REALLY good!
 
1 - 2 of 2 Posts
Top