DiyMobileAudio.com Car Stereo Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
139 Posts
Discussion Starter · #1 · (Edited)
I have been going through my small collection of audio equipment that I'm not using &/or have replaced with different equipment. These never made it to an install & only came out of the box to pose for some pictures.

Audison K6 2-way component set with crossover (for 6.5" midbass & 1.1" tweet) plus a pair of 3" midrange drivers.

SOLD

AV6.5 Woofer Size- 165 mm (6.5″)
Power Handling- 100 W Continuous Power
200 W Peak Power
Impedance- 4 Ω
Frequency Response- 50 ÷ 7k Hz
Sensitivity- 91 dB/Spl
Magnet- High density flux ferrite
Dome- Cotton-Fibre pressed paper with Light Damping treatment

AV3.0 Midrange Size- 70 mm (3″)
Power Handling (Hi-pass filtered 250 Hz @ 12 dB Oct.)‐
100 W Peak Power
Impedance- 4 Ω
Frequency Response- 200 ÷ 14k Hz
Sensitivity- 93 dB/Spl
Magnet- Neodymium
Dome- Cotton Fibre pressed paper with Light Damping treatment

AV1.1 Tweeter Size- 28 mm (1″ ⅛)
Power Handling (Hi-pass filtered 2.0 kHz @ 12 dB Oct.)-
180 W Peak Power
Impedance- 4 Ω
Frequency Response- 1.2k ÷ 22k Hz
Sensitivity- 92 dB/Spl
Magnet- Neodymium
Dome- Tetolon fibre

307184
307185
307186
307187
307188
307190
307191
307192
307193
 

Attachments

·
Registered
Joined
·
32 Posts
Would you be willing to break off the mids separately, and if so at what price?

I need something to pair with some Focal 165FE components I found without crossovers to fill the gap and potentially cut the Focal "sharpness" a bit.
 

·
Registered
Joined
·
139 Posts
Discussion Starter · #3 ·
I'd prefer to sell them together. These are listed elsewhere also & I have had interest but not sold yet. If someone asks for the K6 separately, I'll reach out to see if you're still interested.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top