DiyMobileAudio.com Car Stereo Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Hey all,

I recently purchased a Soundstream Rubicon Class A 10.2 and hooked it up today in my truck as a replacement to some older units. However, when powered up, it is set in high power mode, the clipping lights are on non-stop, and (of course) there is no sound output. The level/gains have been also been adjusted to 0.

I have been searching around the forums/internet for the the last 4 hours and haven't turned anything up that resembles my problem. I know very little about these amplifers and was wondering if anyone could help troubleshoot this?

Regards,
-Harlan.
 

·
Premium Member
Joined
·
498 Posts
The symptoms you describe are of a Rubicon in need of repair.
You can contact DIYMA member Ace956 for repair info.
 
1 - 3 of 3 Posts
Top