DiyMobileAudio.com Car Stereo Forum banner
1 - 3 of 3 Posts

·
Registered
2019 Subaru WRX Base 6-speed
Joined
·
843 Posts
Discussion Starter · #1 ·
So a friend let me use his SMD DD-1 to determine where my stock head unit starts to clip. It's a 2022 WRX Premium and with a 40 hz tone at 29 the clipping indicator flashes ( at 28 it flashes once only ). With a 1khz tone it does not detect clipping even at full volume. Is this normal? I assume 28 would need to be my max volume level so I can set my input gain on my V Eight that I'm using to integrate with. Side note: I will be using LGD-20 from Audio Control so I wont get an error from my StarLink module for not detecting a speaker connected to it, should I re-test after the LGD?
 

·
Registered
2019 Subaru WRX Base 6-speed
Joined
·
843 Posts
Discussion Starter · #8 ·
Thanks Nick, wasn't sure the V Eight would have the right circuitry or not. That'll save a little bit of work at least. I'll be using 28 as my max point, thanks!
 
1 - 3 of 3 Posts
Top