DiyMobileAudio.com Car Stereo Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
60 Posts
I don't know myself, but I found this in some dark corner of the internet:

"[2 channel] amplifiers running in bridged mode accept a single input signal. Normally, the input will be "Channel 1" or "left". Manufacturers vary however, so check the instruction manual for the proper input wiring procedures."

Considering the bridged outputs identified here:
http://www.xtant.com/html/techSupport/pdfs/4180xIns.pdf

I assume you'd have to use the front and rear left channels. Of course I could be wrong.


edit: On the .pdf I linked, you can also see that there's a jumper for 2channel/4channel next to the inputs.
 
1 - 2 of 2 Posts
Top