DiyMobileAudio.com Car Stereo Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
186 Posts
Discussion Starter · #1 ·
Pardon my brain-fart, but I need help w/something really basic.

When bridging my 4-channel xtant down to 2-channel, which rca inputs do I use? Front? Rear?

Thanks, and feel to flame away, as I feel like a dope for not remembering this.

-Ben
 

·
Registered
Joined
·
186 Posts
Discussion Starter · #5 ·
So I leave the input jumper in the 4 channel position? That seems kind of counter-intuitive. Why would they even have the jumper then?

I think I'm just going to call their tech line today.

-Ben
 

·
Registered
Joined
·
186 Posts
Discussion Starter · #7 ·
Just as an update for everyone, I just got done speaking w/tech support at xtant. The person I spoke w/verified that I do not need to use both sets of rca inputs. He stated to set the jumper to 2-channel mode, and just use the front inputs on the amp.

Who knew? :)

-Ben
 

·
Registered
Joined
·
186 Posts
Discussion Starter · #11 ·
The amp's being used to run to my Dayton RS180's, bridged it's rated at 180x2 @ 4 ohm, so they should be seeing 90 each at 8 ohm.

Glad I got this info before I went out and bought y adapters, (was heading that way for lunch, actually.)

-Ben
 
1 - 4 of 4 Posts
Top