DiyMobileAudio.com Car Stereo Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
430 Posts
Discussion Starter #1
after a yr of not getting anything done to my tahoe (while searching for a car to replace my altima that was totaled ) i decided to give my tahoe a face lift!!!!

INA-W900BT

Rf 360.2 (will be replaced by 360.3)

Coustic XM3

Tru Technology B4100 (a-pillars and rear doors)

Tru Technology T03-4.150 (kick panel and front doors)

Tru Technology SH-1 x2 (sub's)

Rockford Fosgate Punch 801S (center console)

Tang Band W4-1320SJ 4" Bamboo Cone Driver x4 (a-pillar)

ScanSpeak Illuminator D3004/6020-00 Tweeter x2 (a-pillar)

Polk Audio SR6500 2-Way 6.5 x2 (kicks panels and rear door)

Ascendant Audio 7" Poly Mids x4 (front doors)

IDMAX10-D2 - Image Dynamics 10" ( in custom center console)

TC Sounds LMS Ultra 5400 18" x2

whatcha think???? I have all the equipment except for the Tang Band W4-1320SJ 4".
 

·
Registered
Joined
·
1,141 Posts
Holy Crap Batman. That is a ton of speakers.

I am confused but interested. Could you explain how you plan to implement this? What freq are routed where?

Just looking at the list I think this is going to be a nightmare to tune. Doing KP and Pillars both with mids and tweets?
 
1 - 2 of 2 Posts
Top