DiyMobileAudio.com Car Stereo Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
433 Posts
Discussion Starter · #1 ·
I would really like to use the Dayton RS tweeter, but I don't think I am going to get it into the factory location on my doors even with some cutom work. Considering the face plate is alum, would it be possible to trim it? Other suggestions for tweeters that reach down to 1.5k?
 

·
Registered
Joined
·
531 Posts
newtitan said:
I saw that S.Buwalda had trimmed some supremos down that he was selling on ECA a few weeks back

so id assume you can do the same to the daytons

there a giy on one of the truck fourms I frequent who screwed the face off, and mounted them using the now open screw holes and some backstrap

See post # 17 for pics

that's an f'ing good idea....and they don't look half bad like that....hmmm...
 

·
Registered
Joined
·
433 Posts
Discussion Starter · #6 ·
newtitan said:
I saw that S.Buwalda had trimmed some supremos down that he was selling on ECA a few weeks back

so id assume you can do the same to the daytons

there a giy on one of the truck fourms I frequent who screwed the face off, and mounted them using the now open screw holes and some backstrap

See post # 17 for pics
I was half wondering if that would be possible looking at those screw heads in the picture. Thanks for the info!
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top