DIYMobileAudio.com Car Stereo Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
82 Posts
I think I was the one who posted the link some time ago :D

@tcguy85 - your soundcard must have a line in (aka microphone symbol) and a line out (aka the headphone symbol).

Both are stereo although you only need the left channel for the calibration. This is not affecting, at all, how you should proceed

1) You need a cable with two 3.5mm jacks (one at each end).
2) plug one jack in the line out
3) plug the other jack in the line in
4) set the sound level as described in the link posted
5) run the calibration

You are done.
 

· Registered
Joined
·
82 Posts
I'm using the mic mate usb connector. Should I do this? I thought it didn't go through the soundcard if it was usb?
Actually, an external soundcard is better the internal ones, especially in the laptops.

So, an USB powered external card is OK - that's what I'm using as the laptop one is very cheap
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top