Car Stereo Forum banner

Tuning frequency for subs

1354 Views 9 Replies 7 Participants Last post by  hurrication
If I use a subwoofer box modeling program to make a ported sub, how do you know what frequency to tune it to, or does most modeling software do that also?

Sent from my iPad using Tapatalk
1 - 1 of 10 Posts
I have not seen a software that will do it for you but I normally just play with the numbers until I get the desired curve. Not too peaky, good smooth roll off, decent amount of mid bass as well. I do this by adjusting the port as well as the box size depending on what i have available.

for me it is hard to explain because I just do it by instinct based on trial and error over the years.
1 - 1 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.