DiyMobileAudio.com Car Stereo Forum banner
1 - 20 of 27 Posts

·
Registered
Joined
·
940 Posts
Discussion Starter · #1 ·
I need another set of mids for my Maxima, as I believe one of my Seas CD18's may be blown:(. I would like to stay with a 7" driver. Give me all your suggestions, as I really haven't established a budget yet - I'll have to see what grabs my attention.

I have about 350wrms @ 4ohms to play with per driver, so I should have ample power to drive most anything I can fit in my doors. This will be in a 2 way setup, and installed with the rest of my system in my sig.

Lemme know whatcha got!

-Matt
 

·
Registered
Joined
·
940 Posts
Discussion Starter · #4 ·
Just curious why you are set on 4ohms? I only ask because there are many quality drivers but most of the are 8ohms DIY/home drivers which is what this site was based on when it was created ;)
You bring up a good point. I guess there really is no reason, as even at 8 ohms I should have enough power to run basically anything I can fit into my door...

I suppose I was just used to having 4 ohm drivers:blush:


NOW OPEN TO ALL SUGGESTIONS!
 

·
Registered
Joined
·
940 Posts
Discussion Starter · #7 ·
Haha fair enough....Well that being said, I got some LNIB Dayton RS180-4 mids for $70 shipped and I will throw in some extra install accessories for you. Let me know :)
You have PM sir!

Not that I am selling them, but would you be interested in Mach 5s at all?
I don't know, I am honestly not familiar with them; which line?
 

·
Registered
Joined
·
879 Posts
Those diamonds would work i bet....Look into and RCF driver, they make a carbon fiber 8 that plays up to 4k i believe.....
 

·
Registered
Joined
·
879 Posts
Not off-axis they don't. ;)
Which driver? I'm sure the 8's won't sound great to 4k off axis, but mating them to a decent tweeter up to 2.5k or so should be ok, no?
 
1 - 20 of 27 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top