[$LICK CALIFA$]

I have bnib 708's if that works

 

[spitfire91104]

I may have a set of the 4ohm versions. Let me check.

 

[420tabbycat]

What use do you have in mind? Have you considered the Dayton Audio Epique line? I’m thrilled with my 7’s in my doors and the 5.5’s model kinda beastly in small spaces for the diameter, they’re more like 6’s from the actual dimensions. On the other hand, I’m thrilled with my DIY 704’s in a .5cf bookshelf set I built with 8” passive radiators. If I remember correctly the Epique 7” with sealed in .5cf with 150-200w models similar spl down low but without the group delay. The Anarchy with a helmholtz resonator probably throbs a little harder than the sealed Epique 7” at the end of the day though. Just a thought I had.

 

[mdnky]

What use do you have in mind? Have you considered the Dayton Audio Epique line? I’m thrilled with my 7’s in my doors and the 5.5’s model kinda beastly in small spaces for the diameter, they’re more like 6’s from the actual dimensions. On the other hand, I’m thrilled with my DIY 704’s in a .5cf bookshelf set I built with 8” passive radiators. If I remember correctly the Epique 7” with sealed in .5cf with 150-200w models similar spl down low but without the group delay. The Anarchy with a helmholtz resonator probably throbs a little harder than the sealed Epique 7” at the end of the day though. Just a thought I had.

I have, but unfortunately I'm limited by the stock pods (relatively thin ABS) and the environment they're being installed in (Jeep, outside w/bikini top 99% of the time). Plan is to run them as midbass, up to maybe 300Hz to 400Hz. Everything else will be handled by some CDT Unity 7.5s, on-axis in pods mounted to the top of the dash. I'll make the final choice on the exact frequencies once everything is installed, during tuning.

So far, the Anarchy 704s are the best for the $$ and the available volume (0.11 cu.ft.), followed very closely by the Dayton ES140TIA & ES180TIA, the GS8nD2s, and the Anarchy 554s. Unfortunately the ES140TIA & ES180TIAs are $140-160/speaker (and 8ohm). I'd rather not drop a lot of money into speakers exposed to the elements, which definitely rules out the GS8ND2s. The Epique E150HE-44 models well, but they're definitely way too heavy for the pods and might run into some clearance issues with the dash. If I didn't have to worry about the elements, I'd probably throw some TB W6s in there.

 

[mdnky]

I have bnib 708's if that works

Might be interested in those for something else, but the current project would be better suited to 4ohm drivers.

I may have a set of the 4ohm versions. Let me check.