DiyMobileAudio.com Car Stereo Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
767 Posts
Discussion Starter #1
Dc1100.1 Ok I have the amp installed everything is power on I have the software updated to 1.41. Settings are set on here everything is essentially fine with the amp itself. The only issue I am having is when I turn on the vehicle the symbilink transmitter box will turn on for like a 1 second then turn right off. I have checked all my connected with a multimeter and rcas I am not sure what is causing this any ideas? I cant get the amp to output because the sldin-t.f isn't working. And it's either the transmitter or the cable because it isn't a official zapco 18ft din cable. But everything does power on and the din cable does have 6 pins. Lmk what you think the issue is. Thanks. I have used zapco dc amps before so I am very understanding with these.
 

·
Registered
Joined
·
767 Posts
Discussion Starter #2
1000 view and no one can help me figure out why the sldin-t.f will power on then immediately power off?
 
1 - 2 of 2 Posts
Top