anyone have any luck finding a tutorial on this yet? or any other instructions on how to use the thing. i cannot get the "help" to work in the program.

 

What do you want to know? I use it almost daily.

 

as mentioned, i cannot get the "help" to work. basically i would like to get the same type of graphs that i have seen on other pages such as bcae1.com. such as the full frequency spectrum with various crossover points and other info. i've already the t/s and enclosure info although i can only seem to get a graph for a few hz.

 

It sounds like you are talking enclosure shop, I don't like it for box modeling as much as LspCAD. Having said that, all LinearX graph fuctions are the same across all products for the most part. All the options you want are in the "calculations" button. Many of the display properties are right click on SPL graph and go to "graph parameters". I am writing this off memory as I don't have Leap at home. My button names could be slightly off.

 

Is there a different thread that may contain some information on how to use LEAP?

I see this thread is quite old. The last version I used of LEAP was the DOS version. I didn't get into the 5.xxx version with the GUI. So it's been years but I definitely need help get started all over again.

Any suggestions/tips would be greatly appreciated.